6" Welded Lid for MK III Closed Loop Essential Oil Extractors Weld On Elbows

6" Welded Lid for MK III Closed Loop Essential Oil Extractors Weld On Elbows6" Welded Lid for MK III Closed Loop Essential Oil Extractors Looking for a lid for your extractor, but it's too costly to have one fabricated for you? Look no farther with this pre welded lid, and leave the fabricating to us! This lid will fit perfectly on any 6" diameter base, and comes pre fabricated with a 1 4" male NPT fitting, a 3 8" male NPT fitting, and a 1. 5" tri clamp fitting with a 1" bore.

Always use a Cold Trap to prevent solvents from being pulled into your pump

Power: 208-230V 60Hz 1-PH

(2) RIMS tubes

Two 3" Single Hinge Tri Clamps

5 x 34" / 38 x 25 x 45" (WxDxH)

3+R:29Apr2016

but your collection pot as well

ceramic tiles

(1) 1/4" FNPT Port

Dual independently controlled heat platens allows the user to control the application of temperature and pressure carefully for maximum results

2" 45° Elbow with 2" Tri Clamp Fittings

Cooling capacity